Powering your Solo Skiff. Solo Skiff Solo Skiff

TRIM PIN - SEE MOTOR

OWNERS MANUAL FOR

DETAILS HOW TO

ADJUST MOTOR TRIM

ANGLE

CAVITATION PLATE

POWERING YOUR SOLO SKIFF

CAUTION!!!

YOU MUST MAKE SURE THE

FRONT OF THE CAVITATION

PLATE IS NOT RUBBING THE

HULL OF YOUR SOLO SKIFF.

THIS WILL CAUSE DAMAGE-

POSSIBLY PUNCTURING THE

HULL, AND OR ALLOWING

WATER IN YOUR HULL. THIS

WILL ALSO VOID YOUR WAR-

RANTY.

IF YOU ARE HAVING TROUBLE ADJUSTING THE MOTOR SO IT DOES NOT RUB CALL YOUR LOCAL

SOLO SKIFF PRO - DO NOT USE BOAT IF IT IS RUBBING OR YOU HAVE A DOUBT

1. Install motor on transom per motor manufacturers instructions.

2. Do not drill through your transom to mount motor.

3. Clamp motor tight enough to avoid slippage off transom.

4. Adjust trim pin on motor so cavitation plate does not touch the hull while under power or at rest.

5. Be sure motor is centered on transom.

6. Double check that cavitation plate does not contact hull.

7. The first time you run the boat, motor a very short distance and double check clearance.

8. DO NOT RUN MOTOR IN TRIMMED UP POSITION- THE PROP CAN HIT HULL

PAGE 6