Rear Panel. DigiTech RP255

Rear Panel

1 2 3 4 5 6 7

1. Input

Connect your instrument to this high-impedance TS input.

2. Amp / Mixer

This button optimizes the RP255’s outputs for use when plugged into a guitar amp or a mixer/ recording device. When set to Mixer (“In” position), speaker compensation is turned on and the outputs are optimized for connecting to a mixer, recording device or headphones. When set to

Amp (“Out” position), the outputs are optimized for running directly in to the input of a guitar amp.

10

3. Left (Mono) and Right Outputs

Connect the Left (Mono) output to the input of a single amplifier (or mixer input) for mono operation. Connect the Left and Right outputs to the inputs of 2 amplifiers (or 2 mixer channels) for stereo operation.

4. Headphones

Connect a pair of stereo headphones to this 1/8" jack. For proper frequency response, the Amp/

Mixer switch should be set to Mixer (“In” position) when using headphones.

Note: The Headphones output can have either a mono or stereo signal, depending on what 1/4" outputs are connected. If neither (or both) 1/4" outputs are connected, the Headphones output will be in stereo. If a cable is connected to the Left (Mono) 1/4" output only, the Headphones output will be in mono.

5. Aux In

Connect the headphone output of an MP3 or CD player using a stereo 1/8" cable to this 1/8" stereo TRS jack for rehearsing with your favorite pre-recorded material. Adjust the output level of your playback device and the RP255’s Master Level knob for the proper volume balance.

6. USB Port

The USB port is for connecting the RP255 to a computer and serves two purposes: (1) for use with the downloadable X-Edit™ Editor/Librarian software, and (2) for streaming audio to and from the computer when using the included Cubase ® LE 4 software. Audio streaming is limited to 2 channels up and 2 channels down from the computer at 44.1kHz, 16 bit and 24 bit. A utility panel in the Editor/Librarian controls the direct/playback mix with any recording software the RP255 is connected to. Knobs 2 and 3 also control the direct/playback mix and USB record level when USB is connected and the Pickup Row is selected.

Note: You can download the X-Edit Editor/Librarian software and USB drivers at www.digitech.

com.

7. Power Input

Connect only the DigiTech ® PS0913B power supply to this jack.

11