Applying Power. DigiTech RP255

Applying Power

Before applying power to anything, set your amp(s) to a clean tone and set the tone controls to a flat EQ response (on most amps, this would be 0 or 5 on the tone controls). Then follow the steps listed below.

1. Turn the amp volume all the way down.

2. Connect the plug of the PS0913B power supply to the power jack on the rear panel of the

RP255.

3. Connect the other end of the PS0913B power supply to an AC outlet. Turn the RP255’s Mas-

ter Level knob (Knob 4) down to “0”.

4. Turn the power of your amplifier(s) to the on position and adjust the volume(s) to a normal playing level.

5. Gradually increase the RP255’s Master Level knob to achieve the desired volume.

2. Connect PS0913B to power jack

4. Turn amp volume up

3. Connect PS0913B to AC outlet

and turn the RP255’s Master

Level to “0”

5. Turn the RP255’s Master Level to the

desired listening volume

1. Turn amp volume down

15