GENERAL ABOUT AQUAPROG. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

GENERAL ABOUT AQUAPROG. Sulzer AquaProg 6 | Manualzz

13 ONLINE TREND MODULE ........................................................................................................ 66

14 OPERATOR LOG ....................................................................................................................... 70

15 SETTING FOR CROSS-REFERENCE ....................................................................................... 71

15.1

CROSS REFERENCE FOR REGISTERS ............................................................................... 71

15.2

CROSS-REFERENCE FOR I/O-BITS .................................................................................... 72

1 GENERAL ABOUT AQUAPROG

1.1 INTRODUCTION

1.1.1 AquaProg

1.1.2 HARDWARE

No real special demands!

A general purpose PC is enough.

A RS 232 adapter is in most cases needed!

1.1.3 SOFTWARE

AquaProg is a Windows based program specially made for setting of substations.

AquaProg can be used for:

Configure substations

Check and acknowledge alarms

Check events

Collect log data

Show the main status of the station

Show the status of the in- and outputs of the controller / panel

Collect and send the configuration data of the substation

Substation software upgrade

Online trend indication

The main purpose to use AquaProg is that it is a simple way of configuring and backing up configurations of the various Sulzer controllers and Sulzer control panels.

1.1.4 SUPPORTED SULZER PRODUCTS

Following Sulzer units can be used in combination with AquaProg:

- CP 112 / 212 - CP 116 / 216

- PC 242

- PCx

- PC 441

-

1.1.5 SUPPORTED OLDER UNITS

Following pruned Sulzer units can also be used in combination with the AquaProg:

- PC 4

- DL 44 / EL 44

- PC 241

- UCE / UP 20

- CPU 30 (PCx)

- PH 4000 / 4100

- SDM 200

- LPP / LSP 4000

- LF / LPF 4100

-

AquaProg only handles one substation at the time.

The substation can be called via a modem or connected via a fixed line directly to a serial port.

Several AquaProg can be started and connected to different substations.

Several AquaProg can also be connected to the same substation, which in some cases can make it easier to read the values from the substation.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 3 of 72

AquaProg can be used together with the Alarm system type ABS AQUAVISION.

AquaProg and AQUAVISION use the same communication software, REPLINE that is installed by both systems.

This means that AquaProg and AQUAVISION

Can be connected to the same substation simultaneously

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 4 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement