CLOSE A SUBSTATION. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

CLOSE A SUBSTATION. Sulzer AquaProg 6 | Manualzz

Station type must be changed if the UP 20 have been upgraded with new software.

A substation, which is not connected to AQUAVISION, can be connected for example after installation of AQUAVISION.

Sometimes it may be good to temporarily disconnect a station from AQUAVISION for example at back-up.

It is only possible to connect substations to AQUAVISION if AQUAVISION is installed and the substation is used by the AquaVision-system.

Click OK, the station is opened.

5.3 CLOSE A SUBSTATION

A substation can either be closed by opening a new or from the menu “Archive” field “ Close substation”.

If anything has en changed since the station was opened AquaProg will ask if the changes should be saved.

5.4 ERASE A SUBSTATION

A created substation can be erased from AquaProg by selecting ”Erase substation” in the “Archive“ menu. The description file of the substation (*.UCM) and the configuration file (*.CFG) will be erased.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 23 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement