DISCONNECT. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

DISCONNECT. Sulzer AquaProg 6 | Manualzz

7.2 DISCONNECT

The substation is disconnected by clicking on one of the buttons shown below in the tool field.

The substation will be disconnected automatically if the AquaProg is closed or the modem does not have a carrier wave (called modem has put down the receiver).

7.3 AUTOMATIC DISCONNECTION

The AquaProg has a function, which automatically disconnects a substation when there is no activity.

Inactivity means that the operator has not mowed the mouse within an adjustable time.

This function can be used to prevent that the operator forgets to disconnect the line after finished job.

Following picture is shown:

Standard value is 60 min.

Above mentioned function is only activated when the substation is connected via telephone modem.

Not direct line (serial port) or radio.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 34 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement