INTERLINKED PARAMETERS. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

INTERLINKED PARAMETERS. Sulzer AquaProg 6 | Manualzz

8.3 INTERLINKED PARAMETERS

Certain parameters in a substation must be set at the same time.

The substation needs all parameters simultaneously for example flow calculation with known points to be able to make the internal calculations after a change.

AquaProg must in this case send all the levels and corresponding flows at the same time, not each parameter separately.

Interlinked parameters are indicated in the configuration tree by an indentation before the actual parameters.

Here is an example of interlinked parameters for flow calculation with known values is shown.

All levels and flows have to be set before they are sent to the substation.

If interlinked parameters are used it is also indicated by the window buttons in the tool row which are lighted.

This button interrupts with-

out writing the parameter values to substation 

This button interrupts and

parameter values to substation.

writes the

If interlinked parameters have been started you always have to finish with one of the buttons above

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 40 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement