PRINTING CONFIGURATION. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

PRINTING CONFIGURATION. Sulzer AquaProg 6 | Manualzz

8.4 PRINTING CONFIGURATION

A connected substation configuration can be printed.

What to be printed is selected by marking a position in the configuration tree.

All information that is in the marked map will be printed.

If you want to for example print all settings in pump pit 1 you do as follows:

1. Mark pump pit 1 in the configuration tree.

2. Start printing by clicking symbol

PRINTER or “Print” in Archive menu.

3. All information, which is available in pumppit 1, will now be printed.

If you mark the root map (on top ”South Central”) the whole configuration of the substation will be printed which produces a lot of paper.

Check that AquaProg is set for correct printer and paper size.

Select “Archive” and “Printer settings” for check.

In some occasion’s it might also be needed to set a scaling if not all information fits.

It is also important that a configuration file is collected from the substation before printing.

Otherwise the printout will be wrong. AquaProg has not correct start values for parameters of the folders. See chapter 7.1, Open direct configuration.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 41 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement