SHOW/ACKNOWLEDGE ALARMS. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

SHOW/ACKNOWLEDGE ALARMS. Sulzer AquaProg 6 | Manualzz

11.3 SHOW/ACKNOWLEDGE ALARMS

The function shows set/active alarms for a substation.

Here it is also possible for the operator to acknowledge alarms.

The function is selected by clicking symbol below:

Or selecting “Collect/Acknowledge alarms” in the Connection menu.

At first information about set alarms is collected from the substation. Then following is shown:

First the number of set, active and not acknowledged alarms are shown

Under alarm category and alarm type you can select what to show in the alarm window.

The alarm window shows alarm number, alarm type , alarm text, ON/OFF status and if the alarm is acknowledged.

With the button “Print” the alarms displayed in the window can be printed.

A separate alarm can be acknowledged by clicking on the alarm in the window ( will be blue marked) and then click on Acknowledge.

With button “Acknowledge all” all alarms in the window will be acknowledged at the same time.

If the substation is coupled to AQUAVISION no alarm acknowledgement is allowed via AquaProg.

Alarm acknowledgement is in this case only allowed by the AquaVision system and is blocked in

AquaProg.

With the button “Update…”you can manually start the reading from a substations

Alarm/Acknowledge status.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 50 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement