SHOW COMMUNICATION STATUS. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

SHOW COMMUNICATION STATUS. Sulzer AquaProg 6 | Manualzz

12 SHOW COMMUNICATION STATUS

Sometimes it is desirable to check the quality of a connected line.

AquaProg has a function, which checks the number of wrong messages from a connected substation.

The function is selected by clicking symbol below:

Or selecting “Show Communication status” in the Display menu.

Repline

Here is information about the communication server Repline.

Connection

Here is information what type of connection is used etc.

Status

Here the number of resending’s is shown as number of messages without answer, which have occurred when in communication with a substation.

The counters are set to zero by clicking “Reset”.

At the same time the actual data transfer speed is shown as number of bits per second and number of messages per second.

When there are to many resending’s and/or a low bit rate it may be advisable to disconnect the line and try again with another line.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 65 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement