SETTING FOR CROSS-REFERENCE. Sulzer AquaProg 6


Add to my manuals
72 Pages

advertisement

SETTING FOR CROSS-REFERENCE. Sulzer AquaProg 6 | Manualzz

15 SETTING FOR CROSS-REFERENCE

The cross-reference table is used when you want to optimise the data flow between the substation and the supervision system. The function is supported for the following Sulzer units:

- CP 116/216

- PC 242

- PC 441

- PCx

- (UP 20)

You can save and collect the cross-reference list for registers and I/O-bits.

These are saved in a separate file, in the catalogue Crossref, in the AquaProg catalogue.

15.1 CROSS REFERENCE FOR REGISTERS

The function is selected by clicking the symbol below:

Or select “Open cross reference register “ in the connection menu.

The picture shows an example of a cross-reference list for registers.

By clicking the button Value/Scale/Polarity it is possible to check the content of the register and find out if the scaling is correct.

Sulzer Pump Solutions AB

AquaProg user guide

2014-08-01

Page 71 of 72

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement