Selecting the Input Signal. HP P1130

P4819A_us.fm Page 13 Friday, September 21, 2001 4:00 AM

NOTE

HP 21” Color Monitor User’s Guide

Selecting the Input Signal

Selecting the Input Signal

You can connect two computers to this monitor using the video input

1 and video input 2 connectors. To select one of the two computers:

1 Move the

1 or 2 switch on the front of the monitor to either

2 The selected input (INPUT 1 or INPUT 2) appears on the screen for 3 seconds.

If no signal is input to the selected connector, the message NO

SIGNAL appears on the screen. After a few seconds, the monitor enters power saving mode. If this happens, switch to the other connector.

Displaying the Current Input Signal

Pressing the button displays the horizontal and vertical frequencies of the current input signal. If the signal matches one of the monitor’s factory preset modes, the resolution is displayed.

English

English

13