Install Trim Kit Frame. Whirlpool MKC2157AS, MKC2150AS, MKC2150AV, MKC2157AV, KMCC5015GBS, KMCC5015GSS


Add to my manuals
12 Pages

advertisement

Install Trim Kit Frame. Whirlpool MKC2157AS, MKC2150AS, MKC2150AV, MKC2157AV, KMCC5015GBS, KMCC5015GSS | Manualzz

Install Trim Kit Frame

1. Position trim kit frame over the opening so that the upper tabs fit inside the rails, as shown.

4. Secure trim kit frame to cutout/cabinet by installing four long wood screws (painted) into the pilot holes drilled in Step 3 above.

NOTES:

A

To ensure vertical centering, install the lower screws first.

To avoid damage to the trim kit frame, do not overtighten screws.

B

C

D

A. Front of trim kit frame

B. Upper tab

C. Rail

D. Lower tab

2. To vertically center the trim kit frame, slide it upward, against the opening, until the upper tabs catch against the top of the rails.

3. Holding the trim kit frame firmly in place, use 7/64" drill to drill four pilot holes into the front facing of the cutout/cabinet through the mounting hole guides in the upper and lower corners of the trim kit frame.

NOTES:

To ensure vertical centering, drill the lower holes first.

The holes will be drilled upward from the bottom, and downward from the top at an angle of about 45°.

A

B

Installation is now complete. Replace any loose items that have been removed from microwave oven cavity.

Save these Installation Instructions for future reference.

C

F

A. Trim kit frame

B. Upper tab

C. Rail

D

E

D. Cutout floor

E. Long wood screw (4 - painted)

F. Mounting hole guide

6

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals