Setting the temperature. Miele KWT 6112 iG ed-cs

Add to My manuals
64 Pages

advertisement

Setting the temperature. Miele KWT 6112 iG ed-cs | Manualzz

The optimum temperature and air quality

Safety device in case of low ambient temperatures

The appliance is equipped with a safety thermostat to protect your wine against a sharp drop in temperature. If the external temperature should fall, a heater element switches on automatically to keep the temperature inside as constant as possible. If the ambient temperature continues to fall, the appliance switches itself off automatically.

Setting the temperature

 Use the two sensors underneath the display to set the temperature.

By touching the sensor

– the temperature will get colder

– the temperature will get warmer.

The following information shows in the display while the sensors are being touched:

– Touching a sensor once: the last temperature selected flashes.

– Each subsequent touch of the sensor: adjusts the temperature shown in 1 °C steps.

– Leaving a finger on the sensor changes the temperature continuously.

A tone will sound (if the sensor tone is switched on) when the lowest or highest possible temperature is reached.

Approximately 5 seconds after the last time a sensor has been touched, the current temperature inside the appliance is automatically shown.

When the temperature is altered, there is a short delay until the temperature selected is set.

The temperature display on the control panel always shows the actual temperature.

 Touch the OK sensor to confirm your selection or

 wait approximately 5 seconds after the last touch of a sensor.

The temperature being set will flash in the display.

25

advertisement

Key Features

  • Precise temperature control (5 - 20°C)
  • Adjustable humidity levels (50 - 80%)
  • Innovative air purification system with Active AirClean filter
  • Elegant design with customizable features
  • Maximum storage capacity: 178 bottles
  • Door alarm and temperature alarm for added peace of mind
  • Feature lighting to showcase your wine collection

Related manuals

Frequently Answers and Questions

How do I adjust the temperature of the wine conditioning unit?
To set the temperature, press the plus or minus buttons on the control panel.
How do I turn on the DynaCool function?
To activate DynaCool, press the corresponding button on the control panel.
How do I clean the Active AirClean filter?
To replace the Active AirClean filter, remove the old filter and insert a new one.

advertisement

Table of contents