For Husqvarna Parts Call 606-678-9623 or 606-561-4983
SECTION 2. SAFETY
This symbol points out important safety instructions which, if not followed, could endanger the personal safety and/or property of yourself and others. Read and follow all instructions in this manual before attempting maintenance on your transaxle. When you see this symbol - HEED ITS WARNING.
WARNING
Wear appropriate clothing. Loose or hanging clothing or jewelry can be hazardous. Use the appropriate safety equipment, such as eye and hearing protection, and safety-toe and slipproof shoes.
Never use compressed air to clean debris from yourself or your clothing.
POTENTIAL FOR SERIOUS INJURY
TOOL SAFETY
Use the proper tools and equipment for the task.
Inspect each tool before use and replace any tool that may be damaged or defective. Inattention to proper safety, operation, or maintenance procedures could result in personal injury, or damage to the equipment.
Before servicing or repairing the 310-2400
IZT, fully read and understand the safety precautions described in this section.
PERSONAL SAFETY
Certain safety precautions must be observed while servicing or repairing the 310-2400 IZT.
This section addresses some of these precautions but must not be considered an allinclusive source on safety information. This section is to be used in conjunction with all other safety material which may apply, such as:
1) Other manuals pertaining to this machine,
2) Local and shop safety rules and codes,
3) Governmental safety laws and regulations.
Be sure that you know and understand the equipment and the hazards associated with it.
Do not place speed above safety.
Notify your supervisor whenever you feel there is any hazard involving the equipment or the performance of your job.
Never allow untrained or unauthorized personnel to service or repair the equipment.
WORK AREA SAFETY
Keep the work area neat and orderly. Be sure it is well lit, that extra tools are put away, trash and refuse are in the proper containers, and dirt or debris have been removed from the working areas of the machine.
The floor should be clean and dry, and all extension cords or similar trip hazards should be removed.
SERVICING SAFETY
Certain procedures may require the vehicle to be disabled in order to prevent possible injury to the servicing technician and/or bystanders.
The loss of hydrostatic drive line power may result in the loss of hydrostatic braking capability.
Proper brake maintenance is very important should this condition develop.
Some cleaning solvents are flammable. Use only approved cleaning materials. Do not use explosive or flammable liquids to clean the equipment.
To avoid possible fire do not use cleaning solvents in an area where a source of ignition may be present.
Discard used cleaning material in the appropriate containers.
310-2400 IZT 7 www.mymowerparts.com
