advertisement
Step
1
Connect the Bottom Frame
Important: Assemble on a level surface.
Gather (Quantity):
(4) Corner Connectors
(4) Tube A
1. Begin at any corner. Assemble corner
(4) Tube B
A connector to tube B. Press button on connector and insert into tube ensuring that the hole in the tube lines up with the button on the connector. It should lock into place.
Slip swedged ends of the tubing into the next piece of tubing.
B
A
2. Assemble tube A to tube B. Continue assembling connectors and tubes. (See Diagram)
Step
2
Complete the Frame
Gather (Quantity):
(4) Tube A
(4) Tube B
(4) Tube E
1. Connect tube E to each of
(4) Corner Connectors
B
A
A the corner connectors.
(See Diagram)
E
2. Insert corner connector to each tube E.
3. Assemble remaining tubes per diagram.
E
B
B
B
B
E
A
A
A
A
B
Swedged
End
B
E
Step
3
Install the Gate Post
Gather (Quantity):
(1) Tube G
(4) End Rail Clamps
(2)
5 /
16
x 2 inch Carriage Bolts with Nut
1. Install the gate post 22 ¼ inches (57 cm) to either side of the corner upright.
2. With the nut on the outside, clamp post to top and bottom frame rails.
3. Check that post is straight up and down. Confi rm that all nuts are tight.
G
22 ¼ inches
(57 cm)
International Customer Care information: visit www.petsafe.net
5
advertisement
