Touch Panel and Temperature Control Board. GE Consumer & Industrial ZIC360NR, ZICS360NR

Add to My manuals
51 Pages

advertisement

Touch Panel and Temperature Control Board. GE Consumer & Industrial ZIC360NR, ZICS360NR | Manualzz

CONTROL SYSTEM

Temperature Control Assembly

Touch Panel and

Temperature Control Board

The temperature control assembly is located at the top front of the fresh food compartment and contains the touch panel and temperature control board.

The temperature control board receives switched

DC voltage from the main control board. Input consists of pins 2 to 3. Failure of input results in default to most recent setting. Pin 1 provides digital communication between the temperature control board and the main control board. Failure of communication results in erratic control.

To remove the temperature control assembly:

1. Remove the light cover.

2. Remove 8 Phillips screws and the light assembly.

Note: Temperature control assembly is mounted on 3 slotted fasteners. Fasteners do not need to be loosened or removed.

3. Carefully cut RTV seal between temperature control assembly and cabinet.

4. Slide the temperature control assembly back to release it from the slotted fasteners and lower the assembly.

5. Disconnect the wiring connector from the temperature control board.

6. Slide the touch panel out of the temperature control assembly.

7. Remove 2 screws and the temperature control board.

Note: Use RTV 102 to reseal temperature control assembly when reassembling.

Light Assembly

Screws

Screws

Touch Panel

P0003340

P0003387

– 21 –

advertisement

Related manuals