CARE AND MAINTENANCE. Ignis AKP 120/01 WH, AKS150/IX/02, AKP 229/01 IX, AKP 135/05 NB, AKP 235/01 WH, AKS 149/02 JA, AKP 202/IX, AKP 233 WH, AKP 233 IX, AKP 102/AP/03


Add to my manuals
10 Pages

advertisement

CARE AND MAINTENANCE. Ignis AKP 120/01 WH, AKS150/IX/02, AKP 229/01 IX, AKP 135/05 NB, AKP 235/01 WH, AKS 149/02 JA, AKP 202/IX, AKP 233 WH, AKP 233 IX, AKP  102/AP/03 | Manualzz

CARE AND MAINTENANCE

Important: never clean the appliance with high pressure water or steam cleaning equipment.

Exterior of the oven

Clean with a damp cloth. If it is very dirty, add a few drops of washing up detergent to the water.

Wipe with a dry cloth.

Do not use corrosive or abrasive detergents, which dull the surface.

In the event that one of these products comes into contact with the oven, immediately clean it using a damp cloth.

Slight differences in colour on the front of the appliance are determined by the different materials used, such as glass, plastic and metal.

Ovens with aluminium front panel

Clean using a delicate detergent and a soft window cleaning cloth or a microfibre cloth that does not leave fibres on the surface. Wipe horizontally, without exerting pressure.

Do not use corrosive products, hard sponges or rough cloths. Clean the aluminium surfaces with a dry cloth.

Accessories

Soak the accessories in water with washing up detergent immediately after use. Food residues can be easily removed using a brush or sponge.

91

Attention: When carrying out the following operations it is advisable to wear protective gloves. These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges.

How to remove the oven door:

1. Open the oven door fully (see fig. 1).

2. Lift the two catches and push them forwards as far as they go (see fig. 2).

1

2

3. Remove the door by closing it partially and pulling it upwards (see fig. 3).

Pay attention to the hinges when cleaning and/or removing the door (fig. 4).

To remount the door:

1. Insert the hinges into their grooves and lower the door fully.

2. Lower the two catches.

3. Close the oven door fully.

Attention: These instructions should be carefully followed both to prevent injury and in order not to damage the oven door and hinges.

Changing the rear oven lamp bulb:

1. Disconnect the oven from the electrical supply.

2. Let the oven cool before turning the lamp cover left to unscrew it (see fig. 5).

3. Change the bulb (see note).

4. Screw the lamp cover back on.

5. Reconnect the oven to the electrical supply.

Note: use only 25 W/230 V, E-14 type, T300°C bulbs available from After Sales Service.

IMPORTANT: Do not use the oven until the lamp cover has been repositioned.

3

92

4

5

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Questions & Answers

2024-05-21

E E C

How to install the oven?
Refer to the manual for detailed installation instructions.
How to connect the oven electrically?
The electrical connection must be performed by a qualified electrician following safety regulations.
What precautions to take when using the oven?
Keep children away from hot surfaces, use oven gloves, and avoid using synthetic material containers for cooking.

Related manuals

advertisement