Inserting Batteries in the Remote Control. Hitachi HDR10T01

Inserting Batteries in the Remote Control

• Remove the battery cover located on the back of the remote control by gently pulling backwards from the indicated part.

• Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries inside. Place the batteries in the correct direction observing the polarity symbols (+/-) and replace the battery cover.

• While using the remote control, you should direct it towards the front panel of the receiver. Remote range is approximately 7m/23ft.

• If your receiver no longer responds to the remote control. it is probable that the batteries are exhausted. If so you can still use the local buttons of the receiver.

You can replace batteries after they are exhausted.

Note : Remove the batteries from the remote control when it is not to be used for a long period. Otherwise it can be damaged due to batteries leaking.

Connecting the Set Top Box to a TV Set

You can connect the set top box to your TV by using the scart socket or HDMI input. Use a scart or HDMI cable to connect the set top box to your TV.

The set top box gives RGB or CVBS output from scart or high definition quality from HDMI output.

- 7 -