First Time Installation. Hitachi HDR10T01

• Highlight Yes or No by using “ ” or “ ” buttons and press OK button to confirm.

• If Yes is selected, automatic search starts.

• Selecting No cancels automatic search.

• After the scanning is completed, your set top box will store all the available channels.

Manual Channel Scan

• Highlight No by using “ ” or “ ” button to cancel installation.

• Highlight Yes by using “ ” or “ ” button and press

OK button to start first time installation.

• After you select Yes, factory settings will be loaded.

• Installation wizard will guide you through the installation process. See the section, “ First

Time Installation” in previous chapters for more information on this process.

IP Settings

• This feature can be used for direct broadcast entry.

• Select Manual Channel Scan by using “ ” or “ ” button and press OK button.

• In manual channel scan, the number of the multiplex is entered manually and only that multiplex is searched for the channels.

• For each valid channel number, signal level and signal quality are shown on the screen.

• In both manual and auto search, any existing channel in the database is not re-stored to avoid duplicates of that channel.

Format Disk

If you want to format the internal hard disk, you can use Format Disk option. ALL the data stored on the

hard disk will be lost in such a case.

• Press OK when the Format Disk option is highlighted. A menu appears, requiring you to enter the pin number. If you have not changed the pin number, the factory default is 0000.

• After you enter the correct PIN code, a pop-up menu appears on the screen to ensure that the hard disk should be formatted.

• Select YES and press OK to format the hard disk.

Select NO and press OK to cancel.

First Time Installation

• If you want to load default settings of your set top box, you can perform first time installation.

• Select First Time Installation by using “ ” or “ ” button and press OK button.

• The following message will be displayed;

- 22 -

• You can configure your receiver’s IP settings by using this menu screen.

• Press YELLOW button to set static IP settings.

• Use BLUE button to configure dynamic IP settings.

• You can press RED button to disable IP configuration.

• In order for the ethernet host to work correctly with your internet connection it needs to have a unique

IP address. In most cases all of the parameters can be provided by the DHCP server in their router. In this case you should use the “ Dynamic” option.

• In the unlikely event that you dou not have a DHCP server in your router or if you prefer to assign your own IP address, then the “ Static” option can be used. You will need to enter a unique IP address along with the default gateway and DNS server. In most domestic networks the default gateway and

DNS server will both be the IP address of the router.

Available MAC address will be displayed on MAC address line.