Power Connection. Grizzly G9956

Power Connection

To avoid unexpected startups or property damage, use the following steps whenever connecting or disconnecting the machine.

1. Set the main switch to "Remote Control."

2. Insert the power cord plug into a matching power supply receptacle. The machine is power supply receptacle. The machine is now connected to the power source.

Figure 4.

Connecting power.

out of the receptacle. Do not pull by the cord as this may damage the wires inside.

Figure 5.

Disconnecting power.

Remote Control

Install the included 9V battery in the remote control. Refer to Page 21 for additional information.

-12-

Test Run

Before you install the model G9956, bench-test the unit to make sure it runs properly.

Note: Do not be alarmed if you notice a small amount of vibration during the Test Run. It is normal for all air filters to produce a small amount of vibration during operation. This vibration is much more noticeable when operating on a hard surface, such as a workbench, compared to when operating in a suspended position, as designed.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, disconnect it from power, then review the Troubleshooting on

Page 20.

If you still cannot remedy a problem, contact our

Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1. Place the air filter unit on the floor or a sturdy workbench.

2. Push the main switch to "Remote Control."

This will ensure the air filter is OFF.

3. Connect the unit to the power source.

4. Push the main switch to "No Remote Control," then pull the switch chain to turn the fan ON.

7. Listen to and watch for abnormal noises or actions. The machine should run smoothly without rubbing noises.

8. Pull the switch chain to turn the fan OFF.

9. Set the main switch to "Remote Control."

10. Push the ON/HR button on the remote control to turn the air filter ON, then push OFF to turn the filter OFF.

Model G9956 (Mfg. Since 8/15)