Operation Controls. Grizzly G9956

SECTION 4: OPERATIONS

Damage to your eyes and lungs could result from using this machine without proper protective gear. Always wear safety glasses and a respirator when operating this machine.

Remote Control

1. Connect power to the air filter.

2. Set the main switch to “Remote Control.”

3. Push the ON/HR button on the remote control to turn the air filter ON. Push OFF to turn it

OFF.

Note: The remote control communicates with the air filter using infrared (IR) and must be pointed directly at the control panel.

Operation Controls

The Model G9956 Double Air Filter can be operated at the machine or with the remote control.

At Machine

1. Connect power to the air filter.

2. Set the main (red) switch (see Figure 10) to

“No Remote Control.”

The remote control will not work when the main switch is in this position.

Main

Switch

Pull Chain Switch

Figure 10. Air filter control panel.

3. Pull the switch chain to turn the fan ON and

OFF.

-16Model G9956 (Mfg. Since 8/15)

Fan Speeds & Timer

You can adjust the fan speed and the length of time the air filter operates by programming it with the included remote control. The ON/HR button allows you to toggle between fan speed and timer control functions.

The five speed lights correspond to the five fan speeds. The following table shows the correlation between the number of lights illuminated on the remote and the fan speed.

No. of Lights

1

2

3

4

5

Fan Speed

800

900

1000

1100

1200

Setting Fan Speed

1. Press the ON/HR button (see Figure 11) once to start the fan. The fan should start to run.

—If one or more of the lower lights comes on, press ON/HR again.

2. Increase the fan speed by pressing the increase button (the right hand pointer).

—Each time this button is pressed, the fan speed increases. The light for the selected fan speed illuminates on the remote control.

3. Decrease fan speed by pressing the decrease button designated by the left hand pointer.

Setting Fan Timer

1. After setting the fan speed, press the ON/HR button.

—If some or all of the lights in the upper row come on, press the ON/HR button once more.

2. Press the increase button to increase the amount of time the fan runs before automatically shutting off.

—Each time this button is pressed, the amount of time increases by two hours, up to a maximum 8 hour cycle. The light for the selected time illuminates on the remote control (see Figure 12).

SPEED

HOUR

CONTINUE

2 4 6 8

Hour

Light at

6 Hours

Decrease

ON

Button

SPEED

HOUR

CONTINUE

2 4 6 8

Increase

OFF

Button

ON/HR OFF

Figure 11. Example of fan speed set at 3.

Model G9956 (Mfg. Since 8/15)

ON/HR OFF

Figure 12. Example of time set for 6 hours of operation.

3. Decrease the amount of time the fan runs before automatically shutting off by pressing the decrease button.

Note: If the automatic shutoff feature will not be used, press the decrease button until the continue light is illuminated.

-17-