AUDIO/VIDEO CONNECTIONS. Motorola DCT2000 45 Pages
AUDIO/VIDEO CONNECTIONS. Motorola DCT2000
advertisement
▼
Scroll to page 2
of
45
AUDIO/VIDEO CONNECTIONS
Before you begin to hook up your DCT2000, review the following:
•
For basic cable connections, use 75-ohm coaxial cables equipped with F-type connectors. You can find coaxial cables in your local electronics store.
•
For audio or video outputs, use cables equipped with RCA and S-
Video type connectors.
•
If you are connecting the coaxial TO TV/VCR connector on the
DCT2000 to the coaxial CABLE / ANTENNA IN connector on the
TV, you must tune your TV to channel 3 or 4.
•
Disconnect power from the DCT2000 before connecting or changing cable connections.
•
Do not place anything on top of the DCT2000, especially other home video components.
9
advertisement
Related manuals
Download
PDF
advertisement
Table of contents
- 8 CONTENTS
- 9 INTRODUCTION
- 12 RECORDING YOUR CONNECTIONS
- 14 BASIC OPERATION
- 14 Turning Power On and Off
- 14 Changing Channels
- 14 Adjusting the Volume
- 14 Electronic Program Guide
- 15 AUDIO/VIDEO CONNECTIONS
- 16 CONNECTING YOUR DCT2000
- 17 Connecting a Mono TV
- 19 Connecting a Stereo TV
- 21 Connecting a Mono TV and Mono VCR
- 23 Connecting a Mono TV and Stereo VCR
- 25 Connecting a Stereo TV and Mono VCR
- 27 Connecting a Stereo TV and Stereo VCR
- 29 Connecting a Mono TV, Mono VCR and Stereo Receiver or Amplifier
- 31 Connecting Dolby ® 5.1, TV, VCR and A / V Receiver
- 33 Connecting Baseband with Dolby ® Digital to a TV, VCR and A / V Receiver
- 35 Connecting a Mono TV, VCR and DVD
- 37 Connecting a Stereo TV, VCR and DVD
- 39 Connecting a TV, Mono VCR, DVD and Stereo Receiver or Amplifier
- 41 Connecting a TV, Stereo VCR, DVD and Stereo Receiver or Amplifier
- 43 Connecting a TV, VCR, DVD and A / V Receiver or Amplifier
- 44 TROUBLESHOOTING