Clearing Paper Jams. KYOCERA KM-3040, CS-3040, CS-2540, KM-2540
Advertisement
Advertisement
6-8
Paper misfeed.
Clearing Paper Jams
1.Open left cover 1 of the m and remove any paper that
2.Open cassette 1.
3.Remove the paper.
4.Reset the cassette and close the cover.
If a paper jam occurs, the touch panel will display Paper misfeed and the copying will stop. Refer to these procedures to remove the jammed paper.
JAM 00
Jam Location Indicators
When a paper jam occurs, the jam location indicators and corrective action are displayed. Jam location indicators indicate the paper jam position, as shown below.
Paper misfeed.
JAM 00
1.Open left cover 1 of the machine and remove any paper that is inside.
2.Open cassette 1.
3.Remove the paper.
4.Reset the cassette and close the cover.
I I
J J
E
K
J E
F
F
C
C
A
B
G
D
H
E
K
E
F
F
C
C
A
B
G
D
Jam Location
Indicators
A
D
E
B
C
F
I
J
G
H
K
Paper Jam Location
Cassette 1
Cassette 2
Optional cassettes 3 and 4
MP tray
Duplex unit, Inside the left cover 1
Inside the left covers 2 and 3
Paper feed unit
Optional built-in finisher
Optional document processor
Optional document finisher
Optional job separator
Reference
Page
After clearing the jam, the machine will warm up again and the error message will be cleared. The machine resumes from the page on which the jam occurred.
Troubleshooting
Troubleshooting
Paper Jam Precautions
• Do not reuse paper cleared from a jam.
• If the paper was torn during removal, be sure to remove any loose scraps of paper from the machine inside. Scraps of paper left in the machine may cause subsequent jamming.
• Jammed paper from the document finisher (option) will be fed out again. Do not return this paper to the document finisher tray.
WARNING High voltage is present in the charger section.
Take sufficient care when working in this area, as there is a danger of electrical shock.
CAUTION The fixing unit is extremely hot. Take sufficient care when working in this area, as there is a danger of getting burned.
Cassette 1
Follow the steps below to clear paper jams in cassette 1.
1
Pull up left cover 1 lever and open left cover 1.
2
Remove the jammed paper.
3
Pull out cassette 1.
6-9
6-10
4
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
5
Push cassette 1 securely back in place.
6
Press the indicated position to close left cover 1.
Cassette 2
Follow the steps below to clear paper jams in cassette 2.
1
Open left cover 2.
2
Remove the jammed paper.
3
Pull out cassette 2.
Troubleshooting
Troubleshooting
4
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
5
Push cassette 2 securely back in place.
6
Close left cover 2.
Optional Cassettes 3 and 4
Follow the steps below to clear paper jams in cassettes 3 or 4 when using the optional paper feeder.
1
Open left cover 3.
2
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
3
Pull out the cassette in use.
4
Remove the jammed paper.
5
Push the cassette securely back in place.
6
Close left cover 3.
6-11
6-12
MP Tray
Follow the steps below to clear paper jams in the MP tray.
1
Remove all papers from the MP tray.
2
If paper is jammed inside, pull the paper toward you to remove.
Inside the Left Covers 1, 2 and 3
Follow the steps below to clear paper jams inside left cover 1, 2 or 3
(option).
1
Open the left cover where paper is jammed inside.
2
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
3
Close the left cover.
Troubleshooting
Troubleshooting
Duplex Unit
Follow the steps below to clear paper jams in the duplex unit.
1
Pull up left cover 1 lever and open left cover 1.
2
Remove the jammed paper.
3
Lift up the duplex unit and remove the jammed paper.
4
Press the indicated position to close left cover 1.
Duplex Unit and Cassette 1
Follow the steps below to clear paper jams in duplex unit and cassette 1.
1
Pull up left cover 1 lever and open left cover 1.
6-13
6-14
2
Remove the jammed paper.
3
Lift up the duplex unit and remove the jammed paper.
4
Pull out cassette 1 and remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
5
Push cassette 1 securely back in place.
6
Press the indicated position to close left cover 1.
Paper Feed Unit
Follow the steps below to clear paper jams in the paper feed unit.
1
Pull up left cover 1 lever and open left cover 1.
Troubleshooting
Troubleshooting
2
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
3
Open the front cover.
4
Turn the lower green knob (A1) clockwise.
5
Remove the jammed paper.
If you cannot remove the paper, proceed with the next step.
6
Pull out the paper feed unit (A2) .
6-15
6-16
7
Open the paper feed unit cover (A3) and remove the jammed paper.
8
Push the paper feed unit (A2) back in place, and close the front cover.
9
Press the indicated position to close left cover 1.
(1)
(2)
Optional Built-in Finisher
Follow the steps below to clear paper jams in the optional built-in finisher.
1
Remove any paper left in the finisher output slot.
2
Remove the output tray.
3
Pull up left cover 1 lever and open left cover 1.
4
Remove the jammed paper.
Troubleshooting
(2)
(1)
5
Press the indicated position to close left cover 1.
6
Reattach the output tray.
7
Turn the dial to lower the finisher process tray.
8
Remove any paper from the tray.
9
Push the tray upward back into place.
Troubleshooting 6-17
6-18
Optional Document Processor
Follow the steps below to clear paper jams in the optional document processor.
1
Remove the original from the original tray.
2
Open the document processor top cover.
3
Remove the jammed original.
A
4
Lift up the paper feed unit A .
5
Remove the jammed original.
If the original tears, remove every loose scrap from inside the machine.
6
Remove the original by turning the dial as shown.
7
Put the paper feed unit A back in place and close the document processor top cover.
8
Reload the originals on the document processor tray.
Troubleshooting
Troubleshooting
Optional Document Finisher
If a misfeed occurs in the optional document finisher, refer to the
Document Finisher Operation Guide to clear the jam.
Optional Job Separator
Follow the steps below to clear paper jams in the optional job separator.
1
If jammed paper can be seen through the paper output slot, pull it out toward you.
If the paper tears, remove every loose scrap from inside the machine.
2
Pull up left cover 1 lever and open left cover 1.
3
Remove the jammed paper.
If the paper tears, remove every loose scrap from inside the machine.
4
Press the indicated position to close left cover 1.
6-19
6-20 Troubleshooting
7 Appendix
This chapter explains how to enter text, describes the paper types that can be used with the machine and lists the machine specifications.
Entering Characters on Touch Panel 7-2
Body ........................................................................................ 7-6
Document Processor (option).................................................. 7-8
Paper Feeder (option) ............................................................. 7-8
Document Finisher (option) ..................................................... 7-9
Built-in Finisher (option)........................................................... 7-9
Job Separator (option)........................................................... 7-10
Environmental Specifications................................................. 7-10
Appendix 7-1

Public link updated
The public link to your chat has been updated.
Advertisement