9.0 Control Functions. Jacuzzi (2014) J-200™

J-200

9.0 Control Functions

9.1 Control Panel

A. LED Display: Can display current water temperature (default display), water temperature set point, selected filtration/heating mode, and error messages.

A

B

C

1

F

D

2

G

E

B. Heat Indicator: Lit when heater is on.

C. Jets 1 Button: Turns jets pump #1 on and off. Press once for low speed; press a second time for high speed; press a third time to turn pump off.

D. Jets 2 Button: Turns high-speed jets pump #2 on and off. Press once to turn pump #2 on; press a second time to turn pump #2 off.

E. Light Button : Turns underwater light (if equipped) and accent lights on in one of three random modes or one of seven solid colors. Refer to Section 10.3 (page 26) for details.

F. Warmer ( ) Button: Increases water temperature set point.

G. Cooler ( ) Button: Decreases water temperature set point.

Operation Details

• Temperature Adjustment: 65 to 104°F (18 to 40°C). Factory default setting is 100°F (38°C).

• LED light system: All LED lights run for 1 hour and then automatically shut off.

• Jets 1/Jets 2 Button Operation: Jets run for 20 minutes when activated, then turn off automatically to conserve energy. Simply press either jets button to continue operation for an additional 20 minutes.

22