Safety Controls. Rheem XE30T06MH45U1, XE40T06MH45U1

Add to My manuals
20 Pages

Rheem XE40T06MH45U1 is an electric water heater designed for manufactured homes. It offers energy efficiency, reliability, and safety features for your hot water needs. With a 40-gallon tank capacity, it can accommodate the hot water requirements of a small household or provide ample hot water for various applications. This water heater is equipped with dual heating elements that ensure a quick recovery rate, reducing wait time for hot water. It features an adjustable thermostat that allows you to set the desired water temperature, providing both comfort and energy savings.

advertisement

Safety Controls. Rheem XE30T06MH45U1, XE40T06MH45U1 | Manualzz

12

Operating the water heater.

CAUTION: Hydrogen gas can be produced in a hot water system served by this water heater that has not been used for a long period of time (generally two weeks or more). HYDROGEN GAS IS EXTREMELY

FLAMMABLE!! To dissipate such gas and to reduce risk of injury, it is recommended that the hot water faucet be opened for several minutes at the kitchen sink before using any electrical appliance connected to the hot water system. If hydrogen is present, there will be an unusual sound such as air escaping through the pipe as the water begins to flow. Do not smoke or use an open flame near the faucet at the time it is open.

Safety Precautions

DO turn off power to water heater if it has been subjected to over heating, fire, flood, physical damage.

Operating Instructions or the

Care and Cleaning section, it is recommended that a qualified person or serviceman perform the work.

DO NOT turn on water heater unless it is filled with water.

DO NOT turn on water heater if cold water supply shut-off valve is closed.

If there is any difficulty in understanding or following the

CAUTION: The cause of the high temperature condition must be investigated by qualified service technician and corrective action must be taken before placing the water heater in service again.

Safety Controls

The water heater is equipped with a combination thermostat and temperature limiting control (ECO) that is located above the heating element in contact with the tank surface. If for any reason the water temperature becomes excessively high, the temperature limiting control (ECO) breaks the power circuit to the heating element.

Once the control opens, it must be reset manually.

To reset the temperature limiting control:

Turn off the power to the water heater.

Remove the jacket access panel(s) and insulation.

The thermostat protective cover should not be removed.

Press the red RESET button.

Replace the insulation and jacket access panel(s) before turning on the power to the water heater.

Emergency Instructions

WARNING: If the water heater has been subjected to fire, flood or physical damage, turn off power to water heater, and do not operate the water heater again until it has been checked by a qualified service technician.

NOTICE: DO NOT use this appliance if any part has been under water.

Immediately call a qualified installer or service agency to replace a flooded water heater. DO NOT attempt to repair the unit! It must be replaced.

advertisement

Key Features

  • Designed for manufactured housing
  • Can be connected for side or top water connections
  • Has both single and double element models
  • Is efficient
  • Has safety controls
  • Has adjustable water temperature

Related manuals

Frequently Answers and Questions

What is the purpose of this manual?
The purpose of this manual is to provide the installer with the basic directions and recommendations for the proper installation and adjustment of the water heater.
Where can I find the model and serial numbers?
You can find the model and serial numbers on a label on the appliance.
What is the maximum water temperature that the water heater can reach?
The maximum water temperature that the water heater can reach is 150°F.
Download PDF

advertisement