advertisement
MAINTENANCE
ATTACHING THE STORAGE HANGER
See Figure 14.
There are two ways to hang the attachment for storage.
To use the hanger cap, push in the button and place the hanger cap over the end of the attachment shaft. Slightly rotate the cap from side to side until the button locks into place.
The secondary hole in the attachment shaft can be used for hanging purposes as well.
STORING THE ATTACHMENT
Store the attachment in a well-ventilated place that is inaccessible to children.
Keep away from corrosive agents such as garden chemicals and deicing salts.
REPLACEMENT PARTS
0.080 in. Twisted Replacement Line (Bulk)............AC04138
0.080 in. Twisted Replacement Line (Pre-cut) .......AC04139
Available at homedepot.com
TROUBLESHOOTING
PROBLEM
Line will not advance when using the auto-feed head
Grass wraps around boom housing and string head
POSSIBLE CAUSE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground level.
SOLUTION
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
Cut tall grass from the top down to prevent wrapping.
CALL US FIRST
For any questions about operating or maintaining your product, call the Ryobi
®
Help Line!
Your product has been fully tested prior to shipment to ensure your complete satisfaction.
9 — English
advertisement