Purging the Whirlpool System. Jacuzzi FUZ7260CCR5CHY, FUZ7242CCR5IWW

Salon™ Spa Bath

Controlling the Waterfall

The waterfall can only be activated when the whirlpool pump is in operation.

The more the waterfall control knob is turned in a counterclockwise direction, the flow of water will increase.

Turning ON...

Turning OFF...

Turning the Waterfall Control knob counter-clockwise will turn on the waterfall

Turning the Waterfall Control knob clockwise will turn off the waterfall

RapidHeat

™

The heater turns ON automatically any time the whirlpool operation is active. Heater operation is not displayed on the control panel. There is a visible indicator light on the heater itself that signifies the heater is operating. The heater will help maintain the temperature of the water in the bathtub.

Vacuum Switch

The heater is equipped with a preset vacuum switch which will not allow the heater to turn ON if the pump is not running and water is not flowing through the whirlpool system.

High-Limit Switch

The heater includes an exclusive High-Limit switch. This safety circuit will not false trip from hot tap water. It will only turn OFF the heater if the thermostat fails. To reset, press the button. If the high-limit trips frequently, please contact us at www.jacuzzi.com, or at 1-800-288-4002.

OVER HEAT

PROTECTION

PUSH TO RESET

High Limit

Reset

HEATER ON

Heater

On

Purging the Whirlpool System

To remove accumulations of bathtub residue from the whirlpool system, it is recommended that a whirlpool bathtub be cleaned at least twice a month. For best results, however, we recommend that you clean your whirlpool bathtub after each use using, Systems Clean™, our exclusive two-part plumbing system cleaner made specifically for whirlpool bathtubs. Systems Clean™ is available through an authorized Jacuzzi Whirlpool Bath Distributor or by calling us direct at 1-800-288-4002.

Bathtub Additives

Do not use oil or oil-based bathtub additives.

If you want to use any kind of bathtub additive, use only a small amount of low-foaming powder or crystal substance; the whirlpool action intensifies the foaming properties of soaps.

The use of certain bathtub oils, bubble baths, and bathtub additives may increase the level of accumulations of bathtub residue in the whirlpool system and may cause false reading of the water level sensors. If excess accumulations persist, you should discontinue use of these products.

Installation and Operation www.jacuzzi.com

Page 21