Operation. Home Decorators Collection 112319

NOTE: The control panel can be accessed at the upper-right corner of the insert.

1

Powering the fireplace

Push the Power button to supply power to all functions of the fireplace and put the insert in a standby mode.

Push the Power button again to turn off all functions.

NOTE: All previous settings are held in memory, so the next time you power up the fireplace, the unit will turn on with the same settings.

NOTE: Holding the Power button on the control panel for

10 seconds will disable the heater function.

2

Adjusting the flame

There are 5 brightness levels that can be selected:

Settings F5 - F1 decrease in brightness

3

Adjusting the heater

Press the Heater button to set the thermostat. The fireplace contains three infrared quartz heating elements.

The thermostat setting range is 62°F - 82°F (17°C - 27°C) or continuously ON. To set flame effect so that it works without heat, press the heater button until the display shows “00”.

The thermostat is adjustable by 2°F or 1°C increments.

4

Setting the timer

Pressing the Timer button will cycle through the timer settings; 30 minutes, 1 Hour, 2H, 3H, 4H, 5H, 6H, 7H,

8H, 9H and off.

NOTE: To change between °F and °C press and hold the

HEATER button on the control panel for 3 seconds.

15

Operation (continued)

5

Replacing the remote control battery

When the remote control stops operating or its range seems reduced, it is time to replace the battery with new ones.

On the back end of the remote, press and slide

the battery door open and remove the old battery.

Insert 2 AAA batteries, checking that the + and -

sides of the battery match inside the battery

compartment.

Replace the battery compartment door.

NOTE: Do not mix old and new batteries. Do not mix alkaline, standard (carbonzinc), or rechargeable (nicad, nimh, etc) batteries. Do not ingest batteries.

6

Disposing of used batteries

The battery may contain hazardous substances that could endanger the enviroment and human health.

This symbol marked on the battery and/or packaging indicates that used battery shall not be treated as municipal waste. Instead it shall be left at the appropriate collection point for recycling.

By correctly disposing used batteries, you prevent potential negative consequences for the environment and human health. Recycling used materials also conserves natural resources.

For more information about collecting and recycling used batteries, please contact your local municipality, your waste disposal service or the point of sale where you purchased this product.

NOTE: Please operate the remote control at a slow measured pace. Press the remote control buttons with an even motion and gentle pressure. Repeatedly pressing buttons in rapid succession may cause the transmitter to malfunction.

NOTE: Batteries should be removed if the product is to be left unused for a long time.

7

Power cord information

This heater is for use on 120 volts. The cord has a plug as shown in the figure.

Connect to properly grounded outlets only.

Do not use a 2 prong adapter. Never use with an extension cord or relocatable power tap (outlet/ power strip).

16

HOMEDEPOT.COM/HOMEDECORATORS

Please contact 1-800-986-3460 for further assistance.