Changing the Programming Code. Rosslare AYC-E60

Reader Operation

Where:

A = The first key entered

B = Second key entered

D = Fourth key entered

E = Fifth key entered

C = Third key entered

EP = Even parity for first 12 bits OP = Odd parity for last 12 bits

If the PIN code is less than 5 digits, all the most significant nibbles are filled with 0.

Example: (EP) 0000 0000 0000 0000 AAAA BBBB (OP)

Where:

A = The first key entered B = Second key entered

EP = Even parity for first 12 bits OP = Odd parity for last 12 bits

3.2.6

Changing the Programming Code

• The Programming code cannot be erased; the code 0000 is invalid and does not erase the Programming code.

• The factory default 4-digit Programming code is 1234.

To change the Programming code:

1.

Enter Programming mode.

2.

Press 3 to enter Menu 3.

Green

The left LED turns red.

3.

Enter the new 4-digit code you wish to set as the Programming code.

You hear three beeps.

The system returns to Standby mode.

3.2.7

Changing the Facility Code

Red Green

Red

AYC-E60 Installation and Programming Manual 27