Setting the Backlight Behavior. Rosslare AYC-E60

Reader Operation

• The Facility code can be in the range of 000 to 255.

• The default Facility code is 0.

To change the Facility code:

1.

Enter Programming mode.

2.

Press 4 to enter Menu 4.

Green

The left LED turns red.

Red Green

3.

Enter the new 3-digit code you wish to set as the Facility code.

You hear three beeps.

The system returns to Standby mode. Red

3.2.8

Setting the Backlight Behavior

To set the backlight behavior:

1.

Enter Programming mode.

Green

2.

Press 6 to enter Menu 6.

The left LED turns red.

Red Green

3.

Enter one of the following codes:

 10 – Always off

 11 – Always on

 12 – Backlight is off, activates for 10 seconds when a key is pressed (left LED also goes on), after which it dims until off (left LED also goes off)

 13 – Backlight is dimmed, activates for 10 seconds when a key is pressed (left LED also goes on), after which it returns to a dimmed level

28 AYC-E60 Installation and Programming Manual