Entering Programming Mode. Rosslare AYC-E60

Controller Operation

You will find instructions for each of the above menu items in the following subsections.

4.9.1

Entering Programming Mode

• The unit must be in Normal mode to enter Programming mode.

• The factory 4-digit Programming code is 1234.

• If a Programming code is not entered within five seconds, the unit returns to Normal mode.

To enter Programming mode:

1.

Press # twice.

The left LED turns off and the right LED turns red.

2.

Enter your 4-digit Programming code.

Red

The right LED turns green.

Green

4.9.2

Exiting Programming Mode

To exit Programming mode:

1.

Press # twice to exit Programming mode at any time.

You hear 3 beeps.

The left LED turns green and the right LED turns off.

Green

Wrong entries reset the controller back to Normal mode.

While in Programming mode, if no key is pressed for one minute, the unit returns to Normal mode.

38 AYC-E60 Installation and Programming Manual