PIN Code Length/Factory Default Settings. Rosslare AYC-E60

Controller Operation

If the assignment digit is valid, three beeps are heard and the controller returns to Normal mode.

If the assignment digit is invalid, a long beep sounds and the controller waits for another assignment digit to be entered.

4.9.16

PIN Code Length/Factory Default Settings

You must be very careful before using this command!

Changing the PIN code length also erases the entire memory contents, including all user and special codes, and returns all codes to their factory default settings.

To change the PIN code length:

1.

Enter Programming mode.

Green

2.

Select the desired PIN code length as follows:

 00 – Returns to factory defaults and sets a 4-digit code

 05 – Returns to factory defaults and sets a 5-digit code

 06 – Returns to factory defaults and sets a 6-digit code

 08 – Returns to factory defaults and sets a 4–8 digit code

When choosing the 4–8 option, please note that you should either enter zeros before the code, or press # at the end (for example if your code is 12345, enter either 00012345 or

12345# ).

Both LEDs flash red.

3.

Enter your 4-digit Programming code.

Red Red

If the Programming code is valid, all memory is erased. You hear three beeps and the controller returns to Normal mode.

If the Programming code is invalid, you hear a long beep and the controller returns to Normal mode without erasing the memory contents.

AYC-E60 Installation and Programming Manual 59