Declaration of Conformity. Rosslare AYC-E60 65 Pages
Declaration of Conformity. Rosslare AYC-E60
advertisement
Declaration of Conformity
A.
Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
AYC-E60 Installation and Programming Manual 63
advertisement
Related manuals
advertisement
Table of contents
- 9 Introduction
- 9 Box Content
- 10 Ancillary Equipment
- 11 Installation
- 11 Mounting
- 12 Wiring
- 12 Wiring the Unit as a Reader
- 13 Wiring the Unit as a Controller
- 16 Reader Operation
- 16 General
- 17 Programming as a Reader
- 18 Entering Programming Mode
- 19 Exiting Programming Mode
- 19 Selecting Keypad Transmission Format
- 24 Selecting HID Prox Card Transmission Format
- 25 Selecting Rosslare Proximity Card Transmission Format
- 27 Changing the Programming Code
- 27 Changing the Facility Code
- 28 Setting the Backlight Behavior
- 29 Setting the Credential Format
- 29 Return to Factory Default Settings
- 30 Replacing a Lost Programming Code
- 31 Controller Operation
- 31 Normal, Secure, and Master Users
- 32 Modes of Operation
- 32 Normal Mode
- 33 Bypass Mode
- 33 Secure Mode
- 33 Changing the Modes of Operation
- 35 Auxiliary Input and Output
- 35 Door Alarms
- 35 Internal Case and Back Tamper
- 35 Lockout Feature (Keypad/Card Tamper)
- 36 REX Function
- 36 Secured Intelligent Power Supply
- 37 Programming as a Controller
- 38 Entering Programming Mode
- 38 Exiting Programming Mode
- 39 Changing Lock Strike Code
- 39 Changing Auxiliary Code
- 40 Changing the Programming Code
- 41 Changing the Normal/Secure Code
- 42 Release Time
- 43 Defining the Auxiliary Input and Output
- 49 Setting the Lockout Feature
- 50 Setting the Backlight Behavior
- 50 Selecting the Credential Format
- 51 Enrolling Primary and Secondary Codes
- 54 Deleting Primary and Secondary Codes
- 57 Relay Codes Assignment
- 59 PIN Code Length/Factory Default Settings
- 60 Replacing a Lost Programming Code
- 60 Replacing a Lost Normal/Secure Code
- 61 Technical Specifications
- 63 Declaration of Conformity
- 64 Limited Warranty