INSTALLATION. Electrolux GK80TSPLCN


Add to my manuals
20 Pages

advertisement

INSTALLATION. Electrolux GK80TSPLCN | Manualzz

ENGLISH 13

Problem

The sensor fields become hot.

There is no signal when you touch the panel sensor fields.

Possible cause Remedy

The cookware is too large or you put it too near to the controls.

Put large cookware on the rear zones if possible.

The signals are deactivated. Activate the signals.

Refer to "Daily use" chapter.

comes on.

comes on.

Automatic Switch Off operates.

The Child Safety Device or the Lock function operates.

Deactivate the hob and activate it again.

Refer to "Daily use" chapter.

7.2 If you cannot find a solution...

If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Give the data from the rating plate. Give also three digit letter code for the glass ceramic (it is in the corner of the glass surface) and an

8.

INSTALLATION

WARNING!

Refer to Safety chapters.

8.1 Before the installation

Before you install the hob, write down the information bellow from the rating plate.

The rating plate is on the bottom of the hob.

Serial number ...........................

8.2

Built-in hobs

Only use the built-in hobs after you assemble the hob into correct built-in units and work surfaces that align to the standards.

the electrical supply for some time. Disconnect the fuse from the electrical system of the house. Connect it again. If comes on again, speak to an Authorised Service Centre.

error message that comes on. Make sure, you operated the hob correctly. If not the servicing by a service technician or dealer will not be free of charge, also during the warranty period. The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet.

During installation in combustible matter,

NIN SEV 1000 and fire protection guidelines and regulations of the

Association of Cantonal Fire Insurance shall be strictly adhered to.

8.3 Connection cable

• The hob is supplied with a connection cable.

• To replace the damaged mains cable use the following (or higher) mains cable type: H05VV-F. Speak to your local Service Centre.

14 www.electrolux.com

8.4 Electrical connection

Install the hob with a socket supply line. If there is no socket supply line, the fixed home electrical system must include an isolating device with at least a 3 mmcontact separation to enable a simultaneous and all-pole cut off from the mains (according to NIN SEV 1000).

8.5

Assembly min.

500mm min.

50mm

55mm

500-530mm

R 5mm

780-810mm

1

2

3

1

2

3

1

2

3

1

2

3

3mm

25-40mm

3mm

25-40mm

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

advertisement