Installation
596
573 559
[mm]
50
*Remove locking nuts for an installed height of 820-821 mm.
** Door length
Cover door with slide function fitted, which means the cover door slides upwards when the dishwasher is opened.
Nominal dimensions. Actual measurements may vary.
• Check that the machine is installed such that the door opens freely, otherwise door lock functionality may be disrupted.
It is important that you read through and follow the instructions and directions below. Conduct installation and connection in accordance with the separate installation instructions.
Safety instructions
• Connections to electricity, water and drainage must be performed by a qualified professional.
• Always follow applicable regulations for water, drainage and electricity.
• Take care during installation! Wear protective gloves! There must always be two people!
• Place a drip tray on the floor beneath the dishwasher to prevent damage from any water leaks.
• Before screwing the dishwasher into place, test the dishwasher by running the Rinse and hold programme. Check that the dishwasher fills with water and drains. Check also that none of the connections leak.
WARNING!
Turn off the water supply when installing the dishwasher!
The plug must be disconnected or power to the socket turned off while the work is carried out!
22
Setup
• The recess and connection dimensions are included in the separate installation instructions. Check that all dimensions are correct before starting the installation. Note that the height of the cover door can be adjusted to match other fittings.
• Make sure the area on which the dishwasher is to be installed is firm. Adjust the adjustable feet so that the dishwasher is level.
Tighten the lock nuts.
• If the dishwasher is built-in the surrounding furnishings must be resistant to any condensation from the dishwasher.
• Affix the protective film (packed in the document bag) to the underside of the worktop. The protective film is to protect the worktop from moisture.
