1.3 Your wireless router
LAN LED
Off : No power or no physical connection.
On : Has physical connection to a local area network (LAN).
WAN (Internet) LED
Off : No power or no physical connection.
On : Has physical connection to a wide area network (WAN).
USB LED
Off : No power or no physical connection.
On : Has physical connection to USB device.
2.4GHz LED / 5GHz LED
Off : No 2.4GHz or 5GHz signal.
On : Wireless system is ready.
Flashing : Transmitting or receiving data via wireless connection.
Power LED
Off : No power.
On : Device is ready.
Flashing slow : Rescue mode
Flashing quick : WPS is processing.
Reset button
This button resets or restores the system to its factory default settings.
7
8
7
8
9
10
11
12
Power button
Press this button to power on or off the stystem.
Power (DC-IN) port
Insert the bundled AC adapter into this port and connect your router to a power source.
USB port
Insert a USB device such as USB hard disk or USB flash drive into the port.
Insert your iPad’s USB cable into the port to charge your iPad.
WPS button
This button launches the WPS Wizard.
Gigabit WAN (Internet) port
Connect a network cable into this port to establish WAN connection.
Gigabit LAN 1 ~ 4 ports
Connect network cables into these ports to establish LAN connection.
NOTES:
• Use only the adapter that came with your package. Using other adapters may damage the device.
• Specifications:
DC Power adapter DC Output: +12V with max 1.5A current;
Operating Temperature
Operating Humidity
Maximum power consumption
Average power consumption
0~40 o C
50~90%
5.65 (W)
2.43 (W)
Storage
Storage
0~70 o C
20~90%
