Taking Pictures using Burst Mode. Panasonic DMCLX2

Add to my manuals
136 Pages

advertisement

Taking Pictures using Burst Mode. Panasonic DMCLX2 | Manualzz

Advanced

Taking Pictures using Burst Mode

1

Press and hold the burst mode button until the burst menu is displayed.

H

L

BURST SHOOTING

OFF

HIGH SPEED

LOW SPEED

UNLIMITED

SELECT SET

MENU

OFF: No display (cancelled)

D

: High speed

E : Low speed

F

: Unlimited

2

Press

e

/

r

or the burst mode button to switch burst mode settings.

• When 5 seconds pass without any operation, the setting selected at the time is automatically adopted.

3

Press [MENU/SET].

• You can also press the shutter button halfway to finish.

• You can also use the joystick to perform steps

2

and

3

.

4

Take a picture.

• Hold down the shutter button fully to activate the burst mode.

n

Number of pictures recorded in burst mode

Burst speed

(pictures/ second)

Number of recordable pictures (pictures)

G H

D

2* max. 3 max. 5

E 1* max. 3 max. 5

F approx. 1

Depends on the remaining capacity of the built-in memory/card.

*The transfer speed of the card has no effect on the burst speed.

• The number of pictures indicated is when the shutter speed is faster than 1/60 and the flash is not activated.

• The burst speed (pictures/second) may become slower depending on brightness and other recording conditions.

To select To set

50

VQT0Y60

Advanced

• When the burst mode setting is set to

Unlimited:

– You can take pictures until the capacity of the built-in memory or the card is full.

– The burst speed will become slower halfway. When the built-in memory is used, the burst speed becomes a maximum of 1 picture approximately every 6 seconds. However, the exact timing of this depends on the number of recordable pictures and the card.

• The focus is fixed in the first picture.

• The ways to control the exposure and the white balance vary depending on the burst mode setting. When the burst mode is set to [ D ], they are fixed to the values set for the first picture. When the burst speed is set to [ E ] or [ F ], they are adjusted each time you take a picture.

• When the self-timer is used, the number of recordable pictures in burst mode is fixed to 3.

• Burst mode is not cancelled when the camera is switched off.

• When the burst mode is activated, the audio recording function cannot be used.

• If the flash is activated, you can record only 1 picture.

• When setting auto bracket and the burst mode simultaneously, auto bracket will be performed.

• In Burst mode, auto review is activated even the setting is off. (The picture is not enlarged.) You cannot change the auto review setting in the setup menu.

• You cannot use burst mode if you have set quality to [RAW].

• You cannot use burst mode with [STARRY

SKY] in scene mode.

51

VQT0Y60

advertisement

Was this manual useful for you? Yes No
Thank you for your participation!

* Your assessment is very important for improving the workof artificial intelligence, which forms the content of this project

Related manuals

Download PDF

advertisement

Table of contents