Switching on. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Switching on. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 26 Tuesday, September 2, 2008 12:33 PM

04

Chapter 4

Before you start

Switching on

Using the Auto MCACC setup for optimal surround sound

When the remote control’s SYSTEM ON button is pressed, the power of both the receiver subwoofer and Blu-ray disc player turns on.

OFF

HDMI 1

BD

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD

INPUT

SELECT

 

TV

FM / AM

The Multichannel Acoustic Calibration (MCACC) system measures the acoustic characteristics of your listening area, taking into account ambient noise, and testing for channel delay and channel level. After you have set up the microphone provided, the system uses the information from a series of test tones to measure standing wave and reverb, optimizing the speaker settings and equalization

(MCACC Effect) for your particular room.

SYSTEM

SURR

ADV.

SURR

F.S.

SURR

The Blu-ray disc player and receiver subwoofer have separate power switches. The power switch for the receiver subwoofer is located on the display unit.

 STANDBY/ON

Receiver subwoofer

Important

• The test tones used for Auto MCACC setup are loud; however, do not turn the volume down during setup as this may result in a sub-optimal setup.

• Make sure the microphone and speakers are not moved during the MCACC setup.

Note

• You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout).

1 Connect the microphone to the MCACC SETUP MIC jack on back of the display unit.

SYSTEM

F.AUDIO

iPod

DISPLAY UNIT

MCACC

SETUP MIC

 STANDBY/ON

Display unit

Button hidden behind the front panel door.

2 Place the microphone at your normal listening position.

Blu-ray disc player

Setting up

26

En

After connecting and installing the Blu-ray disc player and receiver subwoofer, complete the steps below to set the system up for use.

Blu-ray disc player

• Set the OSD language, video and audio output terminals, and the aspect ratio of your TV in the Setup Navigator (page 62).

Receiver subwoofer

• Complete the Auto MCACC setup to optimize the surround sound (see below).

Place it about ear height, and make sure it is level by using a table or chair.

Make sure there are no obstacles between the speakers and the microphone.

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents