Basic operation. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Basic operation. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 27 Tuesday, September 2, 2008 12:33 PM

3 If the receiver subwoofer is off, press SYSTEM ON to turn the power on.

Basic operation

OFF

HDMI 1

BD

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD TV

4 Press SYSTEM CONTROL to set the remote control to receiver control mode.

SYSTEM

GUIDE

TV

VOL

VOL

INFO

MUTE

This manual is split into two parts, one covering using the receiver subwoofer, the other using the Blu-ray disc player. Below are some common operations and where to find them explained in this manual.

Operating the remote control

Make sure that the LCD displays the SYSTEM screen, as shown below.

SURR

SYSTEM

ADV.

SURR

F.S.

SURR

5 Press MCACC.

LINE

SLEEP

TEST

TONE

SOUND

EXIT

The supplied remote control can control not only the receiver subwoofer and Blu-ray disc player, but also other Pioneer products such as Flat Screen TVs, HDD/DVD recorders, and DVD players.

To operate these components, orient the remote control toward the display unit.

Operating the receiver subwoofer

Press SYSTEM CONTROL to display the SYSTEM screen.

The SYSTEM screen is shown on the remote control’s LCD screen, and the remote is switched to SYSTEM mode.

ADV.

SURR

F.S.

SURR

SOUND

RTRV

Try to be as quiet as possible after pressing MCACC . The volume increases automatically and the system outputs a series of test tones.

• To cancel Auto MCACC setup before it has finished, press

MCACC . The unit will continue to use the previous settings.

• If the ambient noise level is too high, Noisy!

blinks in the display for five seconds. To exit and check the noise levels, press

MCACC , or to try again, press ENTER when Retry shows in the display.

• If you see an Error MIC!

or Error Speaker! message in the display, there may be a problem with your mic or the speaker connections. To try again, press ENTER . (If this doesn’t work, press MCACC , turn off the power, and check the problem indicated by the Error message, then try the Auto MCACC setup again.)

• When the MCACC setup is complete, the volume level returns to normal, Complete shows in the display, and MCACC Effect is activated. (See Listening with MCACC Effect on page 33 to switch on/off MCACC Effect.)

• Be sure to disconnect the microphone from this unit upon completion of the Auto MCACC setup.

DISPLAY

TOP MENU

DISC

NAVIGATOR

HOME

MENU

SETUP

GUIDE

TV

VOL

TEST

TONE

PAGE

SYSTEM

VOL

LIGHT

TOOLS

MENU

RETURN

INFO

MUTE

04

Note

• If the room environment is not optimal for the Auto MCACC setup (too much ambient noise, echo off the walls, obstacles blocking the speakers from the microphone) the final settings may be incorrect. Check for household appliances (air conditioner, fridge, fan, etc.), that may be affecting the environment and switch them off if necessary.

• Some older TVs may interfere with the operation of the mic. If this seems to be happening, switch off the TV during Auto

MCACC setup.

• If Complete doesn’t appear, it is likely an error occurred during the setup. Please check all connections and try again.

27

En

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents