Using the LCD touch screen. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Using the LCD touch screen. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 28 Tuesday, September 2, 2008 12:33 PM

04

Operating the Blu-ray disc player

Press BD (HDMI 1) to display the BD screen.

The BD screen is shown on the remote control’s LCD screen, and the remote is switched to Blu-ray disc player control mode.

ON

INPUT

SELECT

SYSTEM

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD

 

OFF

TV

FM / AM

Using the LCD touch screen

Depending on the type of connected component you are operating

(such as a Blu-ray disc player), there may be multiple pages of information for the LCD touch screen. When the component you would like to control is not displayed, press PAGE to scroll to the page where the component you would like to control is located.

• The LCD touch screen’s illumination turns on and off each time the LIGHT button is pressed. The illumination automatically turns off after 30 seconds.

The LCD touch screen’s display turns off after one minute. To have the display shown once again, either touch the LCD or press a button on the remote control.

Watching a Blu-ray disc/DVD

Remember that when using the remote to control the supplied

Blu-ray disc player, you should point the remote towards the display unit, not the player itself.

1 Switches on the system.

OPEN/

CLOSE

Choosing and operating a source component

Press the input select buttons to cycle through connected components.

ON OFF SYSTEM

INPUT

TV

OFF

HDMI 1

BD

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD TV

2 Set the remote control to BD mode.

Press BD (HDMI 1) to set the remote control to BD control mode in order to operate the Blu-ray disc player.

INPUT

SELECT

HDMI 2

DVR

HDMI 3

DVD

 

TV

FM / AM

INPUT

SELECT

 

The selected component changes, and the LCD screen on the remote control changes to that of the appropriate component.

• To select input for Digital 1 , Digital 2 , Analog , Front Audio In , or iPod , press the SYSTEM CONTROL button to set the remote control to the SYSTEM mode, then press the LINE button until the desired input function is shown on the display unit.

SOUND

RTRV

DIRECT

3 Switch on your TV.

Turn on your TV and make sure that it is set to the HDMI video input.

MCACC

TEST

TONE

SOUND

Note

• To temporarily control the receiver while listening to audio from a connected component on this unit, press SYSTEM CONTROL .

The selected input will not change, and the remote changes to

SYSTEM mode. To return to the previous operating mode, press

SYSTEM CONTROL once more.

ON

HDMI 1

BD

SYSTEM

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD

OFF

TV

4 Press  OPEN/CLOSE on the Blu-ray disc player to open the disc tray.

5 Load a disc.

Load the disc with the printed side facing up.

Several dozen seconds are required to read the disc. Once reading is completed, the type of disc is displayed on the player’s front panel display.

28

En

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents