Using the Sound Setup menu. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Using the Sound Setup menu. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 37 Tuesday, September 2, 2008 12:33 PM

Chapter 7

Surround sound settings

Important

• Press SYSTEM CONTROL to set the remote control to receiver control mode in order to operate the receiver subwoofer (make sure that the LCD displays the SYSTEM screen, as shown below).

SYSTEM

GUIDE

TV

VOL

VOL

INFO

MUTE

SYSTEM

SURR

ADV.

SURR

F.S.

SURR

2 Select ‘Sound Setup’.

Use

/

to select, then press ENTER .

TOP MENU TOOLS

DISC

NAVIGATOR

MENU

HOME

MENU

SETUP

RETURN

3 Select ‘ChannelLevel’.

Use

/

to select, then press ENTER .

4 Use

/ to select a channel, or use

/

to adjust the level of that channel.

TOP MENU

DISC

NAVIGATOR

TOOLS

MENU

Using the Sound Setup menu

From the Sound Setup menu you can access all the surround sound settings of the system.

During setup, the speakers are represented by the following letters:

• L – Front left speaker

• C – Center speaker

• R – Front right speaker

• SR – Surround right speaker

• SL – Surround left speaker

• SW – Subwoofer

Channel level setting

HOME

MENU

SETUP

RETURN

• You can adjust the level of each channel by ±10 dB.

5 Press ENTER once when you’re finished.

TOP MENU

DISC

NAVIGATOR

TOOLS

MENU

HOME

MENU

SETUP

RETURN

• If you use the Auto MCACC feature again, it will overwrite the settings you have made here.

The Auto MCACC feature (see page 26) should give you the best surround sound setup. However you may find that by further adjustment of the channel levels you can improve the surround sound in your listening room.

This method of setting the channel levels allows you to listen to a source and adjust the levels of each playback channel.

A further method of setting the channel levels is to use the test tone method. See Adjusting the channel levels using the test tone on page 39 for more on this.

1 Press SETUP.

Note

• When this function is set while MCACC Effect is on, the value for the same function adjusted with the Auto MCACC feature is overwritten.

When MCACC Effect is off, the value set here is applied, regardless of the value adjusted with the Auto MCACC feature.

(The Auto MCACC setting is not overwritten.)

• The range of adjustment is limited when the volume level is set over 51.

Speaker distance setting

HOME

MENU RETURN

The Auto MCACC feature (see page 26) should give you the best surround sound setup. However you may find that by further adjustment of the speaker distance settings you can improve the surround sound in your listening room.

Set the distance of each speaker from your normal listening position.

1 Press SETUP.

2 Select ‘Sound Setup’.

Use

/

to select, then press ENTER .

3 Select ‘Distance’.

Use

/

to select, then press ENTER .

37

En

07

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents