Using this unit for TV audio. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Using this unit for TV audio. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 40 Tuesday, September 2, 2008 12:33 PM

08

Chapter 8

Other connections

Important

• When making or changing connections on the side panel of this unit, be sure to switch power off and disconnect the power cord from the wall socket.

After completing all connections, connect the power cord to the wall socket.

• Press SYSTEM CONTROL to set the remote control to receiver control mode in order to operate the receiver subwoofer (make sure that the LCD displays the SYSTEM screen, as shown below).

SYSTEM

GUIDE

TV

VOL

VOL

INFO

MUTE

Connect the audio output jacks on your TV to the audio input jacks on the receiver subwoofer.

• You can connect by either a digital or analog audio cable. Select only one method to make connections.

• To use the HDMI Control function when you are connected to a supported Pioneer Flat Screen TV, you must connect via HDMI.

• When digital connections are used, it may be necessary to adjust the digital audio output settings on the TV. For details, consult the operating instructions for your TV.

Audio input settings from TVs

(TV Input)

SYSTEM

SURR

ADV.

SURR

F.S.

SURR

To listen to audio from a Flat Screen TV on this device, you will need to connect an audio cable other than an HDMI cable. From this menu, set the audio input to that which you would like to connect.

Press TV on the remote control to switch this unit to the input source selected here. This setting is changed to the selected input and the audio from the Flat Screen TV is output from this device.

Select from inputs Digital 1 , Digital 2 and Analog .

1 Press SETUP.

Using this unit for TV audio

HOME

MENU RETURN

To listen to audio from a TV, connect the TV’s audio cable to one of the inputs on this unit.

Receiver subwoofer

2 Select ‘System Setup’.

Use

/

to select, then press ENTER .

TOP MENU

DISC

NAVIGATOR

TOOLS

MENU

Side panel

IN 1 IN 2

OPTICAL

DIGITAL

ANTENNA

AM LOOP

L

R

ANALOG

AUDIO IN

HOME

MENU

SETUP

RETURN

3 Select ‘TV Input’.

Use

/

to select, then press ENTER .

4 Adjust the setting.

Use

/

to adjust, then press ENTER to confirm.

From digital audio output (optical)

From analog audio output

TV

40

En

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents