Connecting an iPod. Pioneer lx01bd

Add to My manuals
116 Pages

advertisement

Connecting an iPod. Pioneer lx01bd | Manualzz

LX01BD_1.book Page 42 Tuesday, September 2, 2008 12:33 PM

08

Connecting an iPod

Connecting external antennas

You can use the iPod jack on the display unit to playback music from an iPod. All operations can be carried out via the iPod. Use the supplied iPod cable to connect an iPod to this unit.

• When you connect an iPod, this unit’s input automatically switches to iPod .

• Certain iPod models have connectors that are not compatible with this unit.

For an external AM antenna, use 5 to 6 meters of vinyl-insulated wire and set up either indoors or outdoors. Leave the loop antenna connected.

For an external FM antenna, use a PAL connector to hook up an external FM antenna.

External FM antenna

Receiver subwoofer

SYSTEM

F.AUDIO

iPod

DISPLAY UNIT

Display unit

Side panel iPod

ANTENNA

AM LOOP

FM

UNBAL 75 Ω iPod

AM loop antenna

External AM antenna

MENU

PAL connector

Outdoor antenna

Indoor antenna

(vinyl-coated wire) iPod is a trademark of Apple Inc., registered in the U.S. and other countries.

Listening to an external audio source

5 m to 6 m

About control out connections

To listen to audio from a connected external component on this unit, choose its input function on the remote control. Some Pioneer products can be controlled via this remote.

1 If the system isn’t already on, press SYSTEM ON to switch on.

OFF

HDMI 1

BD

INPUT

TV

HDMI 2

DVR

HDMI 3

DVD TV

Also make sure that the external source (TV, satellite receiver, etc.) is switched on.

2 Press LINE to select an audio input source.

SOUND

RTRV

DIRECT

Many Pioneer components support CONTROL connections, by which you can use the remote controls of any connected components by aiming them at the sensor of just one component.

When you use a remote control, the control signal is passed along the chain to the appropriate component.

If you choose to use this feature, you must make sure that you also have at least one set of HDMI or analog audio jacks connected to another component for grounding purposes.

Using a cable with mono mini-plugs on either side (sold separately), connect the CONTROL IN jack on another Pioneer component to the CONTROL OUT jack on the receiver subwoofer.

This will allow you to control the other component by pointing its remote at the display unit supplied with this receiver subwoofer.

42

En

MCACC

TEST

TONE

SOUND

Input sources are cycled through as shown below:

Digital 1 Digital 2 Analog

Front Audio In iPod

The display changes to that of the selected input source.

3 If necessary, start playback of the external source.

Downloaded from www.Manualslib.com

manuals search engine

advertisement

Related manuals

advertisement

Table of contents