advertisement
Inserting Batteries in the Remote Control
• Remove the battery cover located on the back of the remote control by gently pulling backwards from the indicated part.
• Insert two AAA/R3 (2 X 1.5Volt) or equivalent type batteries inside. Place the batteries in the right directions observing the polarity symbols (+/-) and replace the battery cover.
• While using the remote control, you should direct it towards the front panel of the receiver. Remote range is approximately 7m/23ft.
• If your receiver no longer responds to the remote control. it is probable that the batteries are exhausted. If so you can still use the local buttons of the receiver.
You can replace batteries after they are exhausted. Please use only the leak proof batteries.
Note : Remove the batteries from the remote control when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of batteries.
Connecting the Set-Top Box to a TV Set
You can connect the set top box to your TV by using the scart socket. Use a scart cable to connect the settop-box to your TV.
The set-top box gives RGB or CVBS output. If you want to get the picture via scart connector and your TV’s scart connector has an RGB input, then you can switch your digital set-top box to RGB mode, by toggling TV out menu to RGB mode, in con guration menu. So, you will be able to achieve high performance from your digital set-top box.
English - 6 -
advertisement
