advertisement
output differently to normal and widescreen TV sets.
• This function defines the screen format of the connected TV to enable broadcasts’ being displayed correctly.
• Select 4:3 if you have a standard TV set with 4:3 aspect ratio.
• Select 16:9 if you have a widescreen TV.
Note : This function also enables you to change TV
Type that you have previously selected during the
rst time installation.
TV Out
• The set-top-box can output RGB and CVBS signal via the TV SCART connector located on the rear panel.
• Although the RGB format provides a better picture quality, some devices might not support it.
Receiver Upgrade
• To ensure that your set-top-box always has the most update information, you can use this setting. In order for the proper operation, please ensure that the box is set to standby mode.
• The STB automatically powers up at 3.00 A.M. every day and searches for any new software that may be broadcast. If found, the box will download new software automatically. This operation will normally take approximately 30 minutes.
• You can enable or disable automatic upgrade by setting Automatic Scanning option.
• You can manually search for new software by selecting Scan for upgrade .
Menu Locking
• This setting con gures menu locking.
• Select Menu Locking option by using “ ”/“ ” buttons.
• Press OK button to enter the menu.
• To display parental lock menu options, PIN number should be entered. Factory default PIN number is 0000.
After coding the correct PIN number, parental settings menu will be displayed:
Menu Lock
• Menu lock setting enables or disables the menu access. You can disable access to the installation menu or the whole menu system.
Set Pin
• Press OK to display the “ Set PIN ” window. Use numeric buttons to enter the new pin number. You will need to input your new pin a second time for veri cation purposes.
• The factory default pin number is 0000. If you change the pin number make sure you write it down and keep it safe.
Low Power
If you enable low power option, low power mode will be activated. In low power mode the power consumption is less then 1W (in standby).
If you disable low power option the power consumption will be higher than 1W in standby mode however the opening time will be shorter.
Auto Standby
• Press “ ” or “ ” button to select Auto Sleep. Use “
” or “ ” button to set the Auto Sleep to Disabled,
2 Hours, 4 Hours, 6 Hours or 8 Hours.
• After the timeout value is reached, the box will switch off.
System Info
Select System Info and press OK button to display system information.
English - 18 -
advertisement
