Something not Working. BORETTI BRA88

GB

Something not Working

Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions:

SYMPTOM

Door does not close

It is too warm inside the refrigerator

It is too cold inside the refrigerator.

The compressor works continuously.

There is water inside/outside the refrigerator.

Water comes out on the floor.

Noises

SOLUTION

Level properly the appliances if it is not well levelled.

Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out.

The appliance is not properly installed. Please look in the

“Building-in” section.

Set a lower temperature.

Distribute the food products to allow cold air to circulate around them.

Make sure that the door is completely closed and that the insulating strip is complete and clean.

The temperature where the cabinet is placed is above normal room temperature.

Turn the temperature regulator to a warmer setting temporarily.

Turn the thermostat knob to a lower number.

The temperature where the cabinet is placed is above normal room temperature.

Check that the ventilation is sufficient and that the ventilation openings are unobstructed.

The cause could be the introduction of large quantities of food and/or frequent opening/closing of the door.

Sometimes is normal. During automatic defrosting frost thaws on the cooling plate.

Place the drain hose at the back of the cabinet above the drain bowl.

Sometimes this is normal. Temperature control may cause clicking sounds when the system is connected or disconnected.

The injected cooling gas may produce a gurgling sound while passing through the tubes.

The motor may cause a humming noise and/or slight bumping.

The insulation material used has a tendency to slighly increase noise levels, how ever it allows for much better insulation and a lower energy consumption.

57