Positioning / Electrical connection. BORETTI BRA88

Positioning

Unpack the cabinet and check that it is in good condition and free of any transport damage.

The appliance must not be located close to radiators or gas cookers.

Avoid prolonged exposure of the appliance to direct sunlight.

For safety reasons, minimum ventilation must be as shown in Fig.

Attention: keep ventilation openings clear of obstruction.

It is necessary that the niche is provided with a conduct of venti-lation having the following dimensions:

Depth: 50 mm

Width: 540 mm

The climate classification can be found on the rating plate, which is located inside the cabinet on the left hand wall.

The following table shows which ambient temperature is correct for each climate classification:

Climate classification

SN

N

ST

T for an ambient temperature of

+10 to +32 °C

+16 to +32 °C

+16 to +38 °C

+16 to +43 °C

GB

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply.

Voltage can vary by ±6% of the rated voltage.

For operation with different voltages, a suitably sized auto-transformer must be used.

Important

The appliance must be earthed.

The power supply cable plug is provided with a contact for this purpose.

If the domestic power supply socket is not earthed. connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician.

The Manufacturer declines all responsibility if the above safety precautions are not observed.

This appliance complies with the following E.E.C.

Directives:

87/308 EEC of 2/6/87 relative to radio interference suppression.

73/23 EEC of 19.2.73 (Low Voltage

Directive) and subsequent modifications.

89/336 EEC of 3.5.89

(Electromagnetic Compatibility

Directive) and subsequent modifications.

59