Air filtration with the Active AirClean filter. Miele KWT 6322 UG, 10028620

Add to My manuals
80 Pages

advertisement

Air filtration with the Active AirClean filter. Miele KWT 6322 UG, 10028620 | Manualzz

Optimum temperature and air quality

Switching off DynaCool

The wine conditioning unit uses slightly more energy and is a little noisier when the DynaCool function is switched on. You can switch it off now and then if you wish.

 Touch the On/Off sensor of the Dyna-

Cool function so that it is no longer highlighted in yellow.

Air filtration with the Active AirClean filter

The Active AirClean filter achieves optimum air quality by filtering the incoming air.

Fresh air from the room enters the appliance via the Active AirClean filter.

The fans (DynaCool function) then distribute the air evenly throughout the wine conditioning unit.

Filtering the incoming air through the

Active AirClean filter ensures that all air entering the appliance is fresh and free from dust and odors.

This also ensures your wine does not absorb any unwanted odors through the corks.

Replace the Active AirClean filter regularly. The    symbol will appear in the display to remind you (see “Active Air-

Clean filter”).

34

Temperature and door alarm

The appliance is equipped with an alarm system so that the temperature cannot rise or fall unnoticed, which could possibly damage the wine.

Switching the temperature alarm off early

If the acoustic alarm disturbs you, it can be switched off.

Temperature alarm

If the temperature in one of the wine conditioning zones rises or falls by a certain amount, the sensor for that zone will flash in the control panel and at the same time the alarm symbol  will flash in the display. An alarm will also sound.

The audio and visual signals are triggered, for example:

– when the wine unit is switched on and the temperature in one of the temperature zones differs greatly from the set temperature,

– when too much warm ambient air enters the cabinet when bottles are being rearranged or taken out;

– when a large number of bottles are stored for the first time,

– after a power outage.

The alarm will stop and the alarm symbol    goes out as soon as the temperature has dropped to the correct level again. The sensor for the relevant zone will light up constantly again.

 Touch the sensor to turn off the temperature alarm.

The alarm will stop.

The relevant wine conditioning zone will continue to flash in the control panel and the alarm symbol  will continue to flash in the display until the cause of the alarm has been rectified.

35

Temperature and door alarm

Door alarm

An alarm will sound if the appliance door has been left open for longer than approx. 2 minutes. The sensors for the two wine conditioning zones will flash in the control panel. The alarm symbol   lights up on the display.

As soon as the appliance door is closed, the alarm will stop. The sensors for the two wine conditioning zones and the alarm symbol   will go out in the control panel.

If the alarm does not sound in the event of a door alarm, then the alarm has been switched off in settings mode (see “Acoustic signals   ” under “Selecting additional settings”).

Turning the door alarm off early

If the alarm disturbs you, it can be turned off early.

 Touch the sensor to turn off the door alarm.

The alarm will stop.

The wine conditioning zone sensors will continue to flash and the alarm symbol   will remain lit up until you close the door.

36

advertisement

Key Features

  • Built-in Compressor wine cooler 34 bottle(s) Number of temperature zones: 2 Black
  • Number of shelves: 4 Number of doors: 1
  • 35 dB
  • 146 kWh
  • Interior light Temperature alarm

Related manuals

advertisement

Table of contents