Adjusting the door hinge. Miele KWT 6322 UG, 10028620

Add to My manuals
80 Pages

advertisement

Adjusting the door hinge. Miele KWT 6322 UG, 10028620 | Manualzz

*INSTALLATION*

Installation

Adjusting the door hinge

The door hinges on the wine conditioning unit are set at the factory to enable the appliance door to be opened wide.

However, if the opening angle of the appliance door needs to be limited for any reason, the hinge can be adjusted to accommodate this.

If, for example, the appliance door hits an adjacent wall when it is opened, you should limit the opening angle of the appliance door to 90°.

The locking pins for limiting the door opening must be fitted before the appliance is installed.

Reversing the door hinge

The wine conditioning unit is supplied right-hinged. If left-hand hinging is required, the hinges must be changed.

To change the door hinging, you will need the following tools:

 Risk of injury and damage.

The glass door is breakable.

The glass door is heavy. Always change the door hinging with the assistance of another person.

 Risk of injury and damage.

The glass door can drop.

When changing the door hinging, make sure that all fixing parts are securely screwed into position.

Tip: Place a suitable cover on the floor in front of the wine conditioning unit to protect the glass door and your floor from damage when changing the hinging.

Be careful not to damage the door seal. If the door seal is damaged, the appliance door may not close properly and cooling will be insufficient.

 Insert the locking pins supplied for limiting the door opening into the hinges from above.

The appliance door opening angle is now limited to approx. 90°.

61

*INSTALLATION*

Installation

 Remove screws    first from the lower hinge.

 Remove covers   .

 The second person must support the appliance door.

Caution! When the hinge is subsequently released, the door is no longer secure.

 Remove screws    from the upper hinge.

 Remove the appliance door   .

62

*INSTALLATION*

 Place the door with the outer side upwards on a stable surface.

 Risk of injury!

Do not close the hinges.

Installation

 Unclip upper and lower covers   .

 Remove spacer   from the appliance door, rotate it 180° and fit it on the opposite side.

 Remove the screws   .

 Place each hinges    in the corner diagonally opposite from its original position.

63

*INSTALLATION*

Installation

 Replace screws   again.

 Remove covers   .

 Clip covers   back on. Note the position of the notches on the hinges.

 Take off upper retaining bracket   and replace it on the opposite side.

64

*INSTALLATION*

Installation

 Take off lower retaining bracket    and replace it on the opposite side.

 Tighten the screws in upper hinge   .

 Fit appliance door   .

 Risk of injury!

The second person must support the appliance door.

 Tighten the screws in lower hinge   .

 Now install the wine conditioning unit.

65

advertisement

Key Features

  • Built-in Compressor wine cooler 34 bottle(s) Number of temperature zones: 2 Black
  • Number of shelves: 4 Number of doors: 1
  • 35 dB
  • 146 kWh
  • Interior light Temperature alarm

Related manuals

advertisement

Table of contents